I have had a Kaymar Rear Bar with Single Spare Wheel and Dual Jerry Can holder fitted to my Prado 150. The checker plate has quite a gap on the right hand side as can be seen in the attached picture. I was told that this is normal as it has to do with how the body fits onto the chassis. Has anyone had any experience with this and is this gap normal?
Announcement
Collapse
No announcement yet.
Kaymar Rear Bar checker plate fit
Collapse
X
-
Yep, about the same as mine on a GX. All based on templates/instructions, check out Kaymar site for fitting details. But my installer feed the camera cable through that gap not where yours seems to be.
I have since adjusted both arms to be removable; needed to get both arrm cables with a join under checker plate and be able to swap camera between arm and door. Need to remove rear door lower lining and 1" blank grommet each time. So only use arms on bigger trips.
Regards, Gerry
Comment