EGR Clean

[photoprado Avid PP Poster! Find all posts View Profile Close photoprado]

Sorry I wasn't clear. The blanking plate wasn't cut with the tabs in the right position. So gases were going through the hole as well as a very small gap on the edge of plate - which resulted in a noticeable noise due to leak to the engine bay. I think it was operator error on my behalf however with a quick modification to the plate I was able to centre it better and noise went away - success!!

Ok, now I understand. Did you get a photo of the plate, and where did it come from?

Here is Tin's photos of the plates. The closer one is the larger plate for the current 1GD 2.8 and the further one is for the 1KD 3.0

[Schneider Lurker Find all posts View Profile Close Schneider]

Unfortunately I didn't get a photo and I think pulling it out twice is enough times now. I bought it from ebay - should have gone with Tin's version and then I would have got a better fitment. It is done now - next thing UHF install.

[Anth120playdo Banned Find all posts View Profile Close Anth120playdo]

http://www.ebay.com.au/itm/EGR-Blank...item2ca7b6fe5c

happy