Hi!
So I've decided to change the sway bar bushings for a new one. During this process I've broke one of the weld nuts inside the frame, and stripped the other one. I've then retaped the stripped one for +1 size, but that didn't work either - stripped again.
If I could only get the stripped one to break off, I could make a strip of metal, drill two holes in it, and weld two nuts on it, and feed it through the frame (there is an oval opening not too far away) as a counter support. But that f*cker just doesn't want to break off no matter how hard I'm hitting it from beneath with a screwdriver & hammer..
So any idea is appreciated!
Thanks
So I've decided to change the sway bar bushings for a new one. During this process I've broke one of the weld nuts inside the frame, and stripped the other one. I've then retaped the stripped one for +1 size, but that didn't work either - stripped again.
If I could only get the stripped one to break off, I could make a strip of metal, drill two holes in it, and weld two nuts on it, and feed it through the frame (there is an oval opening not too far away) as a counter support. But that f*cker just doesn't want to break off no matter how hard I'm hitting it from beneath with a screwdriver & hammer..
So any idea is appreciated!
Thanks
Comment