Kakadu suspension upgrade - any successes?

[tdog86 Lurker Find all posts View Profile Close tdog86]

Sorry for the delayed response.

We were measuring on the mechanics floor which is as level as it's going to get. Also it was where it was measured pre-lift.

So just so I'm getting this correct:

Install the springs, if I can get an increased I should install a 6mm strut spacer front right corner only? Then bleed the KDSS system after the install of the new shocks and springs?

If it still has a lean will a spring spacer make a difference?

I have bull bar, winch, dual battery, under vehicle protection, rock sliders and roof rack.

What spring rate can you guys recommend?

[fido666 Banned Find all posts View Profile Close fido666]

Assuming the springs are KDSS specific (so different length on driver's side) I would bleed the KDSS after installing the springs but before adding any spacers, that's the only way you will know what hopefully fixes the lean.

[Guest Close Guest]

If your springs are the same, then install the 6mm strut spacers, then do the KDSS bleed.

[fido666 Banned Find all posts View Profile Close fido666]

But if they are different like my Dobinsons would my advice be correct AMTS?

[Guest Close Guest]

I wasn't countering your point. I was adding to it.

[fido666 Banned Find all posts View Profile Close fido666]

Didn't suggest you were, sorry if it sounded that way.

[Guest Close Guest]

Sorry, forgot these

[tdog86 Lurker Find all posts View Profile Close tdog86]

Fido666 are you happy with the Dobinson Springs? They only quote 50-100kg constant load..... My bullbar and which along are 100kg, not including my Rocksliders and Dual Battery.

Amts what springs and spring rate are you running?

I want to be able to rock up on Monday and tell them exactly what I want put in the car.

[fido666 Banned Find all posts View Profile Close fido666]

Fido666 are you happy with the Dobinson Springs? They only quote 50-100kg constant load..... My bullbar and which along are 100kg, not including my Rocksliders and Dual Battery.

Happy so far, could probably have gone the next model down to be honest. Have not measured lately and don't have rocksliders so hard to advise if they will suit your application.

[tdog86 Lurker Find all posts View Profile Close tdog86]

Thanks guys! Appreciate your help!

[tdog86 Lurker Find all posts View Profile Close tdog86]

Do you guys have a copy of what you original measurements before lift with 18" wheels?

[Kowolski Member Find all posts View Profile Close Kowolski]

Kakadu owners wanting to do a lift and retain the existing system should check out Snake Racing in Brisbane. They have a solution.

[slipperyskakadu Senior Member Find all posts View Profile Close slipperyskakadu]

Does the KDSS light stay on dash when swapping out front coils and struts ?

Sent from my SM-G925I using Tapatalk

[slipperyskakadu Senior Member Find all posts View Profile Close slipperyskakadu]

I'm in Alice with a bent strut and broken spring







Sent from my SM-G925I using Tapatalk

[slipperyskakadu Senior Member Find all posts View Profile Close slipperyskakadu]

Is it as simple as pulling out the strut assembly and replacing it ?

What happens with electric part on top ?

Can i run aftermarket upfront and Originals in back ? Or replace the lot ?

Does ARB, TJM or Opposite lock have gear that will fit the Kakadu? Your help will be greatly appreciated.

Does the kdss still work with aftermarket struts ? Is the electric part on top just a auto dampener ?

Cheers n thanks

Sent from my SM-G925I using Tapatalk