Hi All, I have just received a 3" Genie Legendex-2 exhaust system for my 2011 Kakadu & Got Genie to source me a Chip to accompany it (I asked for DP-Chip, They supply Roo Systems) They sent a Rapid Chip programmed by Roo Systems, Has anyone installed this before? I asked for plug and play, however they sent me one which has 7 loose wires.. Red, (positive) Black (Negative) Grey (TPS) and 4 Blue wires (for Injectors i can only assume) The wiring diagram and installation instructions is piss poor (this coming from an instrumentation technician that has seen many a screwed up electrical diagram and wiring systems in my career)
Any help would be appreciated. I have spoken to Wayne at Roo Systems in regards to the Throttle Position sensor wires which where not included in the wiring harness.. but before i ring them up again i was going to hunt around to see what i can figure out first.
The attached images are of what i am dealing with If i do it right....
Any help would be appreciated. I have spoken to Wayne at Roo Systems in regards to the Throttle Position sensor wires which where not included in the wiring harness.. but before i ring them up again i was going to hunt around to see what i can figure out first.
The attached images are of what i am dealing with If i do it right....
Comment