What did you do to your 120 today?

[red hilux Member Find all posts View Profile Close red hilux]

cant remember where I got the fan from. Bought the fan years ago to fit to my other car but never got afound to it.

I do think it is a 10 blade fan for a hilux. Something like this http://www.ebay.com.au/itm/Radiator-...0AAOSwgY9XegvF

the fan is no different to the other fan in the way noise.

My car doesnt overheat at all, but I had it, so why not. I dont think I will really find out how much of a difference it will make tho. My car always runs between 86-88 Ive only ever seen it his 92 once for a split second, that was towing my 1.3t boat up hill, with air con, 37* day

[Wtrxprs007 Senior Member Find all posts View Profile Close Wtrxprs007]

Yesterday she got her tyre rotation, balance and alignment. Caster does not look right. Still saving up for those new superpro upper arms to hopefully bring it back to spec (about 3 degrees positive).

How one does the rear look to you guys? I don't think that left to right differences look right...

[torourke69 Lurker Find all posts View Profile Close torourke69]

Installed new cranking battery.

[rogjil Find all posts View Profile Close rogjil]

When I parked at work took a pic of the 4wd Supacenter 9" LED lights I fitted yesterday

[LowRange Member Find all posts View Profile Close LowRange]

When I parked at work took a pic of the 4wd Supacenter 9" LED lights I fitted yesterday
[ATTACH=CONFIG]24632[/ATTACH]

They look great, they are a whole lot of light for the money. I'm tossing up between these and a light bar, i think i will go the 9".

Today i swapped out all my internal lights with LED's using a kit from Ebay. I done 4 doors, 2 map lights, interior light, rear cargo light, glove box light, and parkers. Really happy with them, much more light.

I also installed the Ozbush Manual Maper, and prepped everything to add the EGR plate tomorrow if the postie has it. I also have the air horns to go in, fire extinguisher to mount and the 3" exhaust has just arrived.

[Bushbasher Out of control poster! Find all posts View Profile Close Bushbasher]

Sold it.

Gone.

Goodbye old friend.

[craigm Addicted PP Member Find all posts View Profile Close craigm]

End of an era Dave..... Goodluck with your new Chariot.

[Graz Senior Member Find all posts View Profile Close Graz]

They look great, they are a whole lot of light for the money. I'm tossing up between these and a light bar, i think i will go the 9".
.

Dont know what the 9inch lights are like but i can tell you there lighbars are crappy.

[rogjil Find all posts View Profile Close rogjil]

Dont know what the 9inch lights are like but i can tell you there lighbars are crappy.

For the cost they sure put out some light and make the standard high beam seem pathetic. However I will be making up my own wiring harness after the Christmas break as it is definitely not a quality item.

[ravenhard Member Find all posts View Profile Close ravenhard]

So had an bit of a boo boo and reversed into the Otto bin and hit directly onto the reverse camera. Smashed the lens and broke the crap bracket which was almost rusted thru away after only 2 years. Was an expensive camera from Polaris at $260. But it was a seriously simple install as I have a pre wired 2008 with the plug already at the back. Was a simple 1 plug install and the camera worked.

Not wanting to spend the same again and not being really happy with the camera I went a different route this time.

I talked to a very a knowledgeable audio installer and bought a camera kit for a gt86. The old camera took a 5V supply from the rear plug. New camera needed 12v accessories so instead of a simple plug and play,I ran the new camera from the headunit to the rear and sourced 12v accessories from behind the headunit

Well I can say the effort was worth it as the new 12v camera is so much clearer and better that the old 1.

The cheery on top is this camera was in $129.

I'd post a photo but I'm sure we have all seen a small camera mounted above a lic plate

[Razorback81 Advanced Member Find all posts View Profile Close Razorback81]

[ATTACH=CONFIG]24614[/ATTACH][ATTACH=CONFIG]24613[/ATTACH][ATTACH=CONFIG]24612[/ATTACH]

Made a start yesterday

Water pump was leaking.

So, new pump, red Toyota coolant, cambelt, 10 blade fan

good job mate ( i need to do my water pump !!)
where did the 10 blade fan come from ??? ( should have read a little further in the posts)

James

[adrian5800 Advanced Member Find all posts View Profile Close adrian5800]

good job mate ( i need to do my water pump !!)
where did the 10 blade fan come from ??? ( should have read a little further in the posts)

James

This is the same part I believe https://goo.gl/photos/YsKaLs7GRRzFQcfT7

[torourke69 Lurker Find all posts View Profile Close torourke69]

Changed oil & filter. What a drama with the filter! I'll be buying the removal tool soon 👍🏻

[Bushbasher Out of control poster! Find all posts View Profile Close Bushbasher]

Kingchrome do a nice box with about 20 different sized adaptors. Easy as.

[LowRange Member Find all posts View Profile Close LowRange]

Dont know what the 9inch lights are like but i can tell you there lighbars are crappy.

Thanks i was leaning more towards the 9" lights over the bar, so this has confirmed it i will go with the lights. I've read a lot of good reports about them and very few complaints. I got my 3" exhaust from 4wdsupacentre (not installed yet due to a hernia slowing me down for a week) but i'm really happy with the build quality of that for the price.

Yesterday i installed the EGR blank and ozbush mapper, but have some kinks to work out today. I've got hardly any power down low, it takes 5 seconds to reach 20km/h and 2,000rpm then after that it takes off like a rocket. It has me stumped...