AMTS Heavy Duty Radiator plate for 120 ARB & Opposite Lock bullbar

[Guest Close Guest]

Upon request by MLC, I started working on a replacement plate for ARB's radiator plate as it has been badly mis-shapen from his many conquests.

Below are pics of the test fit of the prototype. It is made from 3mm steel and now covers the large gap above the factory tie down points which can allow a stick to puncture the radiator.




The test fit was a success and the prototype can now be welded before it gets zinc plated and powder coated.

Photos after welding:


The plate fits ARB and Opposite Lock bullbars.

[Guest Close Guest]

Here is the complete plate after being zinc plated and powdercoated.

Cost is $150 + courier

Here is the bling version after being zinc plated and powder coated:

Cost is $175 + courier

Shoot me an email at amtsprado at gmail dot com if you would like one.

Here it is fitted to MLC's rig.

[Ghost Advanced Member Find all posts View Profile Close Ghost]

Hey amts, would it fit Oposite lock bull bars? If is I'm interested.


Sent from my iPad using Tapatalk HD

[Ghost Advanced Member Find all posts View Profile Close Ghost]

Happy to supply measurements to see


Sent from my iPad using Tapatalk HD

[Guest Close Guest]

Never seen an OL bullbar in real life before. But anything is possible. Might be easier communicating via email regarding the measurements.

[Bushbasher Out of control poster! Find all posts View Profile Close Bushbasher]

Does it have any reinforcing ribs or anything similar? I've bent mine a couple of times and hammered it flat again but now it wobbles in the centre. I could be interested in the new one.

[Guest Close Guest]

There are no reinforcing ribs but there are folds on all 4 sides; and right above the factory tie down points are pockets that are welded in to help with a bit of corner strength where the ARB version has nothing. This plate might be nearly twice as thick also which might assist with the "Rolf Harris effect".

[craigm Addicted PP Member Find all posts View Profile Close craigm]

Heavy Duty Radiator plate for 120 ARB bullbar

I assume that this plate is typical for both the ARB Deluxe and Sahara Bar Andrew?

Edit: Can this be bundled up with your under body protection????
Sent from my iPhone thingy

[Guest Close Guest]

Don't know for sure Craig as I have only measured off and fitted the prototype to ARB Deluxe bars. Anything can be bundled up if you try hard enough

[craigm Addicted PP Member Find all posts View Profile Close craigm]

I'll throw some measurements off mine at you tomorrow night to compare if you wish?


Sent from my iPhone thingy

[Guest Close Guest]

I'll throw some measurements off mine at you tomorrow night to compare if you wish?


Sent from my iPhone thingy

OK thanks! I'll wonder the car yards also.

[Bushbasher Out of control poster! Find all posts View Profile Close Bushbasher]

might assist with the "Rolf Harris effect".

Was alright until I came over a big dune on the Googs Track that bent it over like a ten old over Rolf's knee.

[craigm Addicted PP Member Find all posts View Profile Close craigm]

Was alright until I came over a big dune on the Googs Track that bent it over like a ten old over Rolf's knee.

Thats Gold Bushie.... Pure Gold!!

[foxclan Avid PP Poster! Find all posts View Profile Close foxclan]

Was alright until I came over a big dune on the Googs Track that bent it over like a ten year old over Rolf's knee.

That's the "Rolf Harris effect"

[Bushbasher Out of control poster! Find all posts View Profile Close Bushbasher]

It's the middle leg that you have to look out for!