A few questions regarding this one, and its all due to a pending modification that I'm looking at maybe going for in the near future but I want to make sure that I have exhausted the various possibilities before commiting to one final idea.
Is pipe shown in the following two photos, a single pipe with no further internal capiliaries or similar?
I'm thinking of having the AC system pumped down and disconnecting the pipes for a minor relocation to the new location, shown below.
But I don't want to start the job unless I know that it is a single pipe, and that with a little heat applied to it while disconnected that it wouldn't be an issue adding a couple of extra bends to redirect it.
Any metallurgists out there see an issue with heat and bending?
Any reason why the AC system would not be able to be pumped down topped back up?
Is it a standard pipe?
Thanks fellas.
Is pipe shown in the following two photos, a single pipe with no further internal capiliaries or similar?
I'm thinking of having the AC system pumped down and disconnecting the pipes for a minor relocation to the new location, shown below.
But I don't want to start the job unless I know that it is a single pipe, and that with a little heat applied to it while disconnected that it wouldn't be an issue adding a couple of extra bends to redirect it.
Any metallurgists out there see an issue with heat and bending?
Any reason why the AC system would not be able to be pumped down topped back up?
Is it a standard pipe?
Thanks fellas.
Comment