Hi, the mechanism in the rear passenger side seat has failed. This means that the seat cannot be folded into the upright position (the backrest still folds down but the seat latches don't release). I have established that the seat latch release mechanisms are operated via a series of cables. So as to work out where the fault lies I need to remove the plastic seat base (shown in the first picture), so as to provide access to the release cable routing.
Does anyone know how to remove the base of the seat? There is one screw that I can find but the rest of the base seems to be held in place by the actual seat fabric.
The attached pictures will hopefully make things a bit clearer.
Any suggestions would be appreciated.Thanks
Cheers
Mike
Does anyone know how to remove the base of the seat? There is one screw that I can find but the rest of the base seems to be held in place by the actual seat fabric.
The attached pictures will hopefully make things a bit clearer.
Any suggestions would be appreciated.Thanks
Cheers
Mike
Comment