Hi all,
just after some confirmation about the correct Torque figures to use when changing out the Injectors on a D4d. Have some conflicting figures.
This is what i have
Nozzle Leak Pipes 16Nm
Rear Nozzle Leak Pipe to engine block 13Nm
Nozzle Holder Clamps stretch bolts (the ones that hold the injectors in) 22Nm but have seen 25Nm mentioned as well
Injector Pipes workshop manual i found says 35Nm or 31.9Nm if using SST
Baileys instructions have less than 25Nm
Others say 22Nm
??? So which is it then ? Don't want to over or under tighten the pipes or stretch bolts.
Thanks in advance
just after some confirmation about the correct Torque figures to use when changing out the Injectors on a D4d. Have some conflicting figures.
This is what i have
Nozzle Leak Pipes 16Nm
Rear Nozzle Leak Pipe to engine block 13Nm
Nozzle Holder Clamps stretch bolts (the ones that hold the injectors in) 22Nm but have seen 25Nm mentioned as well
Injector Pipes workshop manual i found says 35Nm or 31.9Nm if using SST
Baileys instructions have less than 25Nm
Others say 22Nm
??? So which is it then ? Don't want to over or under tighten the pipes or stretch bolts.
Thanks in advance
Comment