For those interested in fitting a second fuel filter/water separator I stole this idea from the 120 forum: http://www.pradopoint.com/showthread...The-Full-Story
If you buy all the parts from Cat as described in the fore mentioned post it will bolt straight in. Just ensure the drain port is clear of the inner guard, you may need to tighten the bowl half a turn to gain clearance.
I choose not to use the banjo fittings, preferring to use Speed Flow AN fittings that I believe flow better and are a lot easier to acquire. Lastly I used a little less then a meter of 3/8 hose to join it all up.
All up cost $170 and an hour of my time. Now it only has to prove its self.
If you buy all the parts from Cat as described in the fore mentioned post it will bolt straight in. Just ensure the drain port is clear of the inner guard, you may need to tighten the bowl half a turn to gain clearance.
I choose not to use the banjo fittings, preferring to use Speed Flow AN fittings that I believe flow better and are a lot easier to acquire. Lastly I used a little less then a meter of 3/8 hose to join it all up.
All up cost $170 and an hour of my time. Now it only has to prove its self.
Comment