Announcement

Collapse
No announcement yet.

Electric brake installation

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Electric brake installation

    Does anyone know the easiest spot to splice into cold side of the Brake Pedal switch in the 120 series to install a brake controller?

  • #2
    Re: Electric brake installation

    I ran a (reasonabley heavy duty) twin core wire from the brake controller down the drivers side to the rear RH tail light and spliced in at the brake light there.
    One wire was to the brake light, and the other was the blue wire for the electic brakes.

    The reason I did this and did not connect it at the pedal was because I was running the blue wire to the rear anyway, so I thought I would run both wires in a twin core at the same time and connected at the rear tail ight so I didnt have to solder under the dash.

    I am not sure but I think the stop light wire was yellow with purple strip. DO NOT BANK ON THIS because it was a while ago.

    Bev
    Bevan
    Former - 04 TD GXL, Now 2010 LC200 TD
    Tassie

    Comment

    canli bahis siteleri bahis siteleri ecebet.net
    mencisport.com
    antalya escort
    tsyd.org deneme bonusu veren siteler
    deneme bonusu veren siteler
    gaziantep escort
    gaziantep escort
    asyabahis maltcasino olabahis olabahis
    erotik film izle Rus escort gaziantep rus escort
    atasehir escort tuzla escort
    sikis sex hatti
    en iyi casino siteleri
    deneme bonusu veren siteler
    casibom
    deneme bonusu veren siteler
    deneme bonusu veren siteler
    betticket istanbulbahis
    Working...
    X