Does anyone know the easiest spot to splice into cold side of the Brake Pedal switch in the 120 series to install a brake controller?
Announcement
Collapse
No announcement yet.
Electric brake installation
Collapse
X
-
Re: Electric brake installation
I ran a (reasonabley heavy duty) twin core wire from the brake controller down the drivers side to the rear RH tail light and spliced in at the brake light there.
One wire was to the brake light, and the other was the blue wire for the electic brakes.
The reason I did this and did not connect it at the pedal was because I was running the blue wire to the rear anyway, so I thought I would run both wires in a twin core at the same time and connected at the rear tail ight so I didnt have to solder under the dash.
I am not sure but I think the stop light wire was yellow with purple strip. DO NOT BANK ON THIS because it was a while ago.
BevBevan
Former - 04 TD GXL, Now 2010 LC200 TD
Tassie
Comment