Modified my 130W IPF,s buy installing 38W 6000K H3 HID lamps and Igniters.
Rear View of lamp housing with Rubber Grommets I Blank 1 new 25mm, hole was cut using a chassis punch, painted then h3 lamp and grommet installed.
I bench tested the first lamp housing with reflector out of housing for 4hours, then a futher test with the grommets installed for 2 hours no problems with excessive heat.
Sealed grommets with RTV silicon and WP connections with silicon grease.
Rear view of lamps and Wiring runs.
[Underside view of igniter mount.
My $12 NARVA Switch from REPCO "Thanks Chippy"
Rear View of lamp housing with Rubber Grommets I Blank 1 new 25mm, hole was cut using a chassis punch, painted then h3 lamp and grommet installed.
I bench tested the first lamp housing with reflector out of housing for 4hours, then a futher test with the grommets installed for 2 hours no problems with excessive heat.
Sealed grommets with RTV silicon and WP connections with silicon grease.
Rear view of lamps and Wiring runs.
[Underside view of igniter mount.
My $12 NARVA Switch from REPCO "Thanks Chippy"
Comment